收了一套 亚克力机械爪的散件，准备尝试组装一下。
All parts
2 left claw +2 right claw +4 half claw +2 plate fixer
双通铜柱 Double copper column
铜柱 copper pillar
螺母 Nut
螺丝 Screw
Prepare several parts of the picture and start assembling the left paw.
铜柱M312 copper pillar M312
双通M310+6 Double copper column M310+6
螺丝M38 Screw M38
双通铜柱M312 Double copper column M312
螺丝M38 Screw M38
The top four: single copper column M3*10+6
The bottom two: double copper column M3*12
Use M3*8 screws to fix.
Left claw completion.
Prepare the parts and start to install the right side claw.
Pay attention to the difference from the left paw.
铜柱M310+6 Copper column M310+6
双通铜柱M312 Double copper column M312
螺丝M38 Screw M38
舵机部件 steering engine parts
舵机螺丝 steering engine screw
The bottom two is the M3*12 double copper column.
Use two steering screws to fix the white parts in the internal measurement.
Prepare the parts and start to install the middle support.
双通铜柱M320 Double copper column M320
螺丝M38 Screw M38
M2螺母 M2 nut
螺丝M28 Screw M28
螺丝M310 Screw M310
铜柱M310+6 Copper column M310+6
After the installation is shown, as shown in the picture
螺丝M38 Screw M38
螺丝M310 Screw M310
此位置的螺丝先不装
The screws in this position are not installed at first
螺丝M38 Screw M38
螺丝M28 Screw M28
螺母M2 nut M2
铜柱M310+6 Copper column M310+6
Underline: you can also use M3*12+6’s single copper column instead.
For example, the following 1, 2, 3 three parts are assembled into a whole.
The screw of the steering gear is here.
舵机螺丝 steering engine screw
M3螺母 M3 nut
The M3 nut is installed at the bottom.
Screw M3*8 on top
Screw M3*10 underneath
装好的是这个样子
固定到底座之上
（待续）
